![]() ![]() There are three included sketches you can use on the OpenLog, depending on your particular application. On power up, you will see either 12> or 12 indicates OpenLog is ready to receive commands. You can now open up a serial monitor and interact with the OpenLog. That's it! Your OpenLog is now programmed with new firmware. Open the OpenLog sketch you would like to upload under Tools>Board menu, select the "Arduino/Genuino Uno", and select the proper COM port for your FTDI board under Tools>Port. Please double check the example circuit if you are not sure how to do this properly. If you haven't yet, connect your OpenLog to the computer via an FTDI board. Save the file, and open up the Arduino IDE. Change BUFFERED_TX to 0 and ENABLE_RX_ERROR_CHECKING to 0. Next, to take advantage of the modified libraries, modify the SerialPort.h file found in \Arduino\Libraries\SerialPort directory. GitHub: OpenLog > Firmware > OpenLog_Firmware.The SdFatLib and Serial Port libraries are not visible in the Arduino board manager so you will need to manually install the library. Looking for the Latest Versions? If you would prefer the most up-to-date versions of the libraries and firmware, you can download them directly from the GitHub repositories linked below. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |